Technical Data; Product Description - Kinderkraft LUMI Manual De Uso

Technical data:

Battery power supply: 4 pcs x AAA 1.5 V
Power supply via USB-DC cable (included): requires a power supply unit with USB-A port with the following
output parameters: voltage 5.8V, minimum current 1A.
Remote control power supply: 1 pc x CR2025 3 V

Product description

no.
A
C
E
Product assembly/disassembly:
Follow the fig. Ia and Ib.
The installation should take place on a soft ground that will not damage the surface of the elements. All parts
of the rocker (A,B,C) should be carefully inspected after taking it out of the box and make sure that none of
them are damaged. Place the foot of the rocker (B) on the ground. With both hands, grasp the seat (A) and
gently push the seat pin into the hole in the foot. When the elements connect, you will hear a characteristic
sound (click). Attention! The seat pin and the hole in the foot are D-shaped. Adjust the shape so that the seat
can connect to the foot without obstacles or force. Slide the toy bar (C) onto the seat frame.
To dismantle the product, press the metal button at the back of the foot of the rocker (Figure II) and then,
with firm move, separate the seat from the foot of the rocker.
The rocker has a rocking function. If you want the seat to swing to the sides, move the locking button upwards
(Figure VII). Attention! Do not activate the rocker function if the button is in the motion blocking position.
The rocker has two belt heights. Choose one of these depending on the size of your child.
Cushion adjustment
Adjustment is by means of a Velcro strap (Figure VIII). By sliding the belt buckle down, you can adjust the
cushion lower, while by pulling the belt buckle up, you can adjust the cushion higher. Velcro straps on the
adjusting belt and cushion are used to stabilize the position of the cushion.
Installation/replacement of batteries in the rocker:
To install or replace the batteries, use a Phillips screwdriver (not included), unscrew the safety flap from
element B (one screw) and replace the batteries paying attention to polarity. Follow the figure VI
Replacing the remote control batteries:
To replace the batteries, follow the drawing on the back of the remote control. Press and hold the button,
and then slide out the battery compartment. Discard the dead battery and insert a new one, paying attention
to the polarity (plus up). Slide the battery compartment.
Product control:
You can control the rocker using a remote control (D) as well as the touch panel on the foot of the rocker
(not included)
Item description
Seat
Toy bar
USB-DC cable
(included in the set)
no.
B
D
21
Item description
Rocker foot
Remote