Velleman HAA86C Manual Del Usuario página 4

- Add group of cards
Example : You want to add 10 cards and the first card number is 060003, followed by 060004, 060005, 060006,
etc.
Enter **NUMERIC CODE
**123456
Next, you should either press 060003 (enter lowest card number first) or hold the card next to the reader.
Conclude the operation by entering 10##9 (10 = number of added cards).
e. Deleting Access Card(s)
- Delete single card
- Delete group of cards
f. Programming the Alarm Output Duration
Press #51 (programming alarm output duration).
Enter the number of seconds the alarm should sound (= TTT, programmable between 1 to 254 seconds). Example:
Press #5138# to activate the alarm for 38 seconds.
Conclusion: Press #51TTT# to set the "alarm output duration".
g. Programming the Door Delay Close Time
Press #52 (programming door delay close duration).
Enter the number of seconds the alarm should sound (= TTT, programmable between 1 to 255 seconds). Example:
Press #5238# to activate the alarm for 38 seconds.
Conclusion: Press #52TTT# to set the "door delay close time ".
h. Enabling the Beeper Signal Output
Press #54 (enabling the beeper signal output).
The output time will be activated according to the previously set door delay close time or door open duration.
Example: The door delay close time or door open duration has been set to 10 seconds. If the door is open and not
closed within 10 seconds, the alarm will sound to warn the user.
Conclusion: Press #54# to enable the beeper signal output.
i. Disabling the Beeper Signal Output
Press #55 (disabling the beeper signal output).
Once the beeper disabled, the alarm will not sound even when the door delay close time or door open duration has
been exceeded.
Conclusion: Press #55# to disable the beeper signal output.
HAA86C_v3
: Press #3. Enter the complete card number (6 digits) OR hold the card in front of the
reader (< 10cm). Next, you should enter X ##9 (X = the number of cards to be added).
Start with the card with the lowest number.
# ADD GROUP OF CARDS. In other words:
# 3.
: Press #2 and hold the card next to the reader or enter the complete card number (6
digits), then press ##9.
: Press #4. Enter the complete card number (6 digits) OR hold the card in front of the
reader (< 10cm). Next, you should enter X ##9 (X = the number cards to be deleted).
Start with the card with the lowest number.
4 VELLEMAN