Metal Cutting; Laser Safety - NUTOOL MPK500 Manual Del Usuario

Dust extraction adaptor (pic.8)
This Jigsaw is equipped with a bayonet fitting dust extraction adaptor
(fig 8). Which can be fitted to a vacuum cleaner or suitable dust
extraction unit. To fit the dust extraction adaptor, fit the rubber "O" ring
onto the smaller diameter on the dust extraction adaptor and locate it
into the dust outlet at the rear of the machine. Push in firmly and twist
to engage the bayonet lugs.

Metal cutting

When cutting metals a suitable cooling/cutting oil must be used. Simply
squirt the lubricant onto the blade or work piece at regular intervals
during cutting to reduce blade wear.
Note: Do not immerse in water or allow coolant to enter the casing. A
fatal electric shock could occur.
Circle cutting
When starting a cut from the centre of the work piece, drill a 12mm
diameter hole to ensure that there is enough clearance for the blade.
Tip
When cutting materials with a decorative or polished finish cover either
the base of the Jigsaw or the surface of the material being cut with
masking or other suitable tape to prevent scratching.
Voltage
Motor Capacity
No load speed
Cutting Angles
Sound Pressure Level
Sound Power Level
Vibration Level
Weight
Max cutting capacity
Wood
Plastic
Steel
MPK500
230V ~ 50 Hz
500 W
500-3000 min
-1
45°
LpA 84.6 dB(A)
LWA 97.6 dB(A)
4.22 m/s
2
2 kg
65 mm
10 mm
8 mm
17
MPKL800 (pic. 9)

Laser safety

The Laser guide line used in this product uses a class 2 Laser with a
maximum power output of 1.5mW at a wave length of between 635
and 670nm. These lasers do not normally present an optical hazard,
although staring at the beam may cause temporary flash blindness.
WARNING! Do not stare directly at the Laser beam.
The laser shall be used and maintained as detailed in this manual.
Never intentionally aim the laser beam at any person and prevented it
from being directed towards the eye or an object other than the work
piece.
Always ensure that the laser beam is directed at the work piece only
when it is located on the mitre saw table.
Never direct the laser beam onto any bright, shiny reflective surface,
the laser beam could be reflected back towards the operator.
Do not change the laser unit for any other type.
Do not tamper with the laser unit except when making adjustments.
Repairs to the laser must only be carried out by an authorised service
centre.
MPKL800
230V ~ 50 Hz
800 W
500-3000 min
-1
45°
LpA 84.6 dB(A)
LWA 97.6 dB(A)
4.22 m/s
2
2,9 kg
100 mm
15 mm
10 mm
GB