Product Maintenance - Fellowes POWERSHRED 425Ci Manual Del Usuario

ADVANCED PRODUCT FEATURES
SAFESENSE ®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
2
1
( ) to activate look for the SafeSense
SafeSense indicator to illuminate
®
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
TO CLEAN THE SENSORS
2
1
Lift CD flap
shredder
AUTO OIL
Automatically oils the cutters to enhance performance and extend shredder life.
(Auto oil system is only included on cross-cut models - 425Ci and 485Ci)
REFILLING THE OIL
1
Low oil indicator will
signal when your reservoir performance, refill oil
needs refilling reservoir with up to 12
oz. (355 ml.) of shredder
oil (Fellowes 35250)
remove plug and let oil drain out. Replace plug.
4
TECHNOLOGY OPERATION
3
SafeSense is active and If hand is held on SafeSense
®
working properly area more than 3 seconds
®
shredder will shut off
3
Locate Auto-start
infrared sensor
TM
2
3
oiling will resume
standby mode and sleep mode.
4
WHEN IN SLEEP MODE
1
®
In sleep mode
4 5
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
reservoir as instructed for optimum performance.
ENGLISH
Models 425Ci/425i/485Ci/485i
ENERGY SAVINGS SYSTEM
Optimal energy efficiency 100% of
the time – in use and out of use.
2
3
or insert paper
touch control panel