Connecting Cord Set - Briggs & Stratton 071014 Manual De Instalación Y Del Operario

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
4. As shown in Figure 7, cut, strip, and connect each
wire to the appropriate terminal on the locking
receptacle on the inlet box inner panel. Use the
schematic affixed to the inside of the inlet box to
make proper wire connections. When all
connections have been made, reinstall the inlet
box inner panel.
Figure 7 — Inlet Box Connections

Connecting Cord Set

From the two 120/240 Volt connection plugs supplied
with the transfer switch, select the one that mates to
the generator. Referring to the image in Figure 8 and
the schematic in Figure 9 or Figure 10 that applies to
the connector being used, properly attach the plug to
the pigtail end of the connecting cord set.
Figure 8 — Receptacle Connection
INSTALLATION
www.mymowerparts.com
Figure 9 — 20A Cord Set Connector
4-Wire Cord Set
Y (Hot)
NEMA L14-20
Figure 10 — 30A Cord Set Connector
4-Wire Cord Set
Y (Hot)
NEMA L14-30
12
240V
120V
120V
W (Neutral)
X (Hot)
Ground (Green)
240V
120V 120V
W (Neutral)
X (Hot)
Ground (Green)