Power Source - Ricatech RTT77 Manual De Usuario

Unpacking
1 Remove packing materials from unit.
Note: Save all packing materials.
2 Remove plastic bag covering radio.
3 Remove AC Adaptor from packing.
4 Untie antenna wire on back of radio.
5 Remove black tie-wrap from under the tone arm.
6 Remove white protective needle cover by gently pulling towards the front of the unit.
7 Install the top lid onto the unit
8 Untie the FM antenna and allow it to hang down in a straight line for optimum FM reception.
If you have trouble tuning in an FM Station, move the external FM antenna for best
reception. Do not connect FM antenna to outside antenna

Power Source

1. Unwind the AC POWER CORD at the back of the unit and connect it to a power outlet.
2. Plug A/C cord into appropriate outlet.
Lid Installation
1 Flip the LID LOCK HINGE towards the back of the unit.
2 Position LID over the turntable and press the lid onto
the LOCK HINGE as shown below.
3 As you press the lid into place, align the PIVOT PINS on
the LID with the LID PIVOT POINTS as shown below.
4 Press the LID all the way in until the PIVOT PINS snap into
the LID PIVOT POINTS and the LOCK HINGE clicks into place.
click