Maintenance - Bravo 200 DGT Manual De Instrucciones

When the three values have been set: i.e. time, temperature and motor speed, to
start the drying or any hair treatment you have to press the ( 7 ) (START) button.
The temperature (6) and the motor speed (4) can be changed during the hair treat-
ment or drying time. The treatment time cannot be changed once the (START)
button has been pressed. To make any changes you have first to press the ( 8 )
(STOP) button. Set the treatment time again. Press the ( 7 ) (START) button to
start the treatment again.
The hair dryer stops automatically at the end of the treatment time, and a sound
signal is given.
To avoid blasts of cold air, the mod. 200/205/210 DGT automati-
cally positions on speed 1 and at maximum temperature for the first
minute of operation. Once this heating period has passed, the mod.
200/205/210 DGT automatically and gradually increases motor
speed until the set speed is reached.
During the last minute of treatment, the mod. 200/205/210 DGT
cools the hair, lowering the temperature automatically to 35°C; this
way, the operator does not have to work on hot air, which would be
fragile during setting.
5.

MAINTENANCE

Before carrying out any cleaning work unplug the electrical cable from the socket.
The hair dryer model 200/205/210 DGT does not need special maintenance work,
the only recommendation is to keep the external parts clean so that the aeration
holes do not get clogged up. When you clean the outside of the equipment do not
use cloths impregnated with detergent as these may penetrate into the equipment.
It is advisable to use a damp cloth or a cloth dampened with denatured alcohol
(pink).
Ed. 21/04/2009
- 18 -