GBC eWire Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
E.
Clearing Jams:
When a jam occurs in the eWire™, identify the
location of the jam, and clear the excess paper,
starting with Area 1 and proceeding to Area 2, 3,
and 4. After clearing any jam, return to area
3b and remove any wire that may be present
Area
Area 1 – Bypass Paper Jam
Area 2 – Bypass Transfer or Stacking
Area Paper Jam
Area 3a– Twin Loop Wire Feed Jam
Description
If paper is jammed in Area
1, raise the top cover and
remove
the
jammed
paper. Raise the lower
transport by lifting on the
handle.
Remove
any
paper trapped between
the bypass region and the
stacking region.
If paper is jammed in Area
2, raise the top cover and
the lower bypass by lifting
the handle to access the
stacking region. Raise the
vacuum stacker handle to
remove paper from the
stacking area. Sheets may
be partially hooked onto
the wire segment.
Open the front door and
slide out the drawer using
the handle provided. Check
if the rewind paper from the
spool has been cut or
damaged. Check that the
wire feed from the spool
has enough slack. Check
for any excess wire in the
Feeder area.
Do not remove cover or place fingers behind it.
Area 4 – Book Tray Jam
7
eWire™
ro
GB
No wire should be present
beyond the knife area. If
wire is present past the
knife, use the wire cutters
provided to cut and remove
it, then position the wire as
shown in Section 7 B Step
11. When cutting excess
wire, cut it just before the
knife. Lift the wire off of the
plastic
nose
to
damaging it. Remove any
excess wire past the knife
by turning the belt knob
clockwise. Do not pull wire
from belt teeth
Sharp Edge!
Cut finger with contact
If it is necessary to remove
a piece of wire from under
the knife cover, first try
turning the element feed
knob counter clockwise,
do not reach under the
cover with your fingers. If
you cannot remove the
wire using the knob, use
the wire cutters provided
to grab the wire and pull it
free.
Open the Book Tray by
pulling on the door handle.
If the book tray is full,
remove all books from the
elevator and close the
door firmly. Check for any
debris or loose paper in
the book tray area.
avoid

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7716507

Tabla de contenido