Electrical Specifications; Electrical Features - bossauto IONIZER PRO Manual De Instrucciones

User Manual
EN

3. Electrical specifications

3.1. Electrical features

Specifications
Input voltage 5VDC.
Max. charging current 550mA.
Output voltage +/6500V Tol.:10%.
Max. output voltage <=20uA.
Max. working power 1.5W.
Laser pointer 650nm <1mW Class II
Input: 110/230V 50/60Hz
Charger
Output: 5Vdc 750mA
Internal battery LIPO 1800mAh 3.7v
500 full cycles: battery 100%
Battery charge cycles
(3000 Hours)
* For best battery performance, it is recommended to
completely exhaust the battery charge before recharging.
3.2 Air lines
Aluminum and stainless steel air lines are the most efficient
ones. We do recommend filtering the air with 2-body
models, water + oil filtering (Bossauto code: 050436), or
3-body models, water + oil + active carbon (Bossauto code:
050384). This type of air filters are the most efficient to use
either with the IONIZER PRO or for painting tasks.
4. Equipment operation and
maintenance
4.1. Installation and operating instructions
The IONIZER PRO gun does not require any installation
previous to its use.
However, it is recommended to observe the following
instructions about its starting and operation:
1. Connect the IONIZER PRO gun to the charger.
2. The lit green LED indicates that the gun is ready to use.
3. Once the gun is charged, unplug the gun from the charger
and connect to the air line.
4. Pull the trigger. The laser indicates the area that is being
decontaminated and ionizing.
5. Application is the same as painting, without changing the
distance, speed or pressure.
9