MZ electronic NAUTI 030 Instrucciones De Uso página 24

Setting up to count in feet
Carry out the first four steps described above for programming in metres.
5
Press
(-F-) feet.
6
Press the
the setting in feet. The words
LOAD FEET will run across the
display screen.
7
At this point the instrument will set
up to count chain deployment in
feet – in 1, 2 or 3 foot increments
depending on the size of the gipsy.
Note
IF PROGRAMMING OPERATIONS ARE SUSPENDED FOR
MORE THAN 60 SECONDS THE INSTRUMENT WILL
AUTOMATICALLY RELOAD THE PREVIOUSLY SET
DATA.
NAUTI 030
. The display will show
.button to confirm
24
English
Rev. 05 – 2007