Product Description - Eazyzap FD496 Manual De Instrucciones

• The appliance is not to be
used in locations where
flammable vapour or explosive
dust is likely to exist.
• Do not use in barns, stables
and similar locations.
• EAZYZAP recommend that
this product is connected
to a circuit protected by an
appropriate RCD (Residual
Current Device).

Product Description

FD496 - LED Insect Killer - Small - 15W
FD497 - LED Insect Killer - Medium - 19W
FD498 - LED Insect Killer - Large - 24W
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your EAZYZAP product.
Pack Contents
The following is included:
• Insect Killer
• Instruction manual
• Hanging chain
EAZYZAP prides itself on quality and service,
ensuring that at the time of packaging the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your EAZYZAP dealer immediately.
Installation
Note: Ensure the mounting substrate and
the fixings used can support the weight of
the appliance. If in doubt seek professional
advice or assistance.
1. Remove all packaging and protective film from
the Insect killer.
FD496-FD497-FD498_ML_A5_v3_20210128.indb 3 FD496-FD497-FD498_ML_A5_v3_20210128.indb 3
2. For best results, locate the Insect killer in the
darkest part of the room, but at least 1 metre
away from food preparation areas.
Note: Close proximity to other light sources
such as sky lights and windows will reduce
the effectiveness of the Insect killer.
3. Connect the appliance to mains power.
Operation
WARNING: Under no
circumstances should hands be
placed anywhere near the high
voltage grid when the appliance
is operational.
The insect killer works by luring insects on to an
electrified metal grid using ultra-violet light. It
uses no chemicals and is pollution free. To use the
Insect killer:
1. Press the switch to the ON (I) position. Ensure
it is set to OFF (O) before plugging into mains.
2. The light will come on and the grid will become
electrically charged.
Cleaning, Care &
Maintenance
Always switch off the power
and disconnect the appliance
from the power supply before
cleaning.
• Clean the collection tray regularly with warm
soapy water.
• DO NOT immerse the appliance in water. Wipe
the safety guard and external casing with a
damp cloth.
• Change the bulbs every 12 months.
UK
3
2021/1/28 16:38 2021/1/28 16:38