Honeywell HE360 Manual De Instrucciones página 7

8. Make sure the humidifier housing is level, then position it in the opening so the plastic tabs are in place on
the upper sheet metal edge of the opening.
Use pliers, as necessary, to flatten cut edges. See Fig. 5.
9. Push in securing clips until completely seated.
10. Drill holes and install the three sheet metal screws on the top of the humidifier housing. Secure the hous-
ing with the three remaining screws.
11. Reinstall the humidifier pad assembly in the humidifier housing.
IMPORTANT
Be sure to reconnect the water feed tube and ensure that the tube is not pinched or kinked.
12. Hinge the cover in place and secure with the thumbscrew located at the bottom of the cover.
PLASTIC
TABS (2)
SHEET METAL
SCREWS (4)
DRAIN TUBING
Fig. 5. Installing humidifier on duct.
HE360 HUMIDIFIER AND INSTALLATION KIT
DUCT
LEVEL
OPENING
TO AIR DUCT
7
M20204C
69-2631ES—05