Installation Instructions; Required Tools - Franke CAMB20VP Instrucciones De Instalación Y De Seguridad

INSTALLATION INSTRUCTIONS

Required tools

You will need the following tools for the installation of the baby changing station:
Fixings supplied
The following fixings are supplied with the baby changing station:
Measuring tape in order to install the changing station
to the appropriate height and distance
Phillips Head Screwdriver in order to tighten the
fasteners of the changing station
A level in order for the changing station to be installed
completely horizontal to the ground
A pencil for the appropriate installation markings
A drill to make all the necessary holes for the
installation
1 Ø 10 mm masonry drill bit (a special drill for brick,
masonry or cement walls with widia tip).
Six self-tapping Philips screws (DIN 7981/C A2 of
Ø6.3x70 mm) for fixing the changing station to the wall
Six Ø10mm nylon plugs to insert into the installation holes
of the changing station
Four flat washers (DIN125 M8 A2) to be mounted with
four Ø6.3x70 mm self-tapping Philips screws below the
metal structure
Four blunt Philips screws (DIN7985 A2 M4x8 mm) to
fasten the liner dispenser to the metal wall structure
Four flat washers (DIN125 M4 A2) to be mounted with
four blunt Philips screws (M4x8 mm) to fasten the liner
dispenser