Troubleshooting Guide - Philips AVENT SCF260 Manual De Instrucciones

Troubleshooting Guide
The temperature of warmed food depends on the consistency of the food. Philips AVENT recommends
that, ideally, pureed food only should be heated with this warmer. If you find that thicker food is not
Food is not
warm enough at the end of the warming cycle, fill the warmer with an additional 30ml/1oz of water.
warm enough
On step 4 and 5, choose the food from room temperature mode and programme the warmer at the
30ml/1oz option. Before feeding your baby, stir the food. Always check food temperature before feeding.
If you find that milk is not warm enough at the end of a warming cycle, fill the warmer with an additional
Milk is not 30ml/1oz of water. On step 4 and 5, choose the milk from room temperature mode and programme the
warm enough warmer at the 30ml/1oz option. Before feeding your baby, shake the bottle or storage container gently
and check the temperature of the milk by sprinkling a few drops on the back of your hand.
Display will
not illuminate Check that the lid is closed correctly. Check that the mains lead is plugged into the mains and the power
/ Warmer will outlet is switched on. Then hold the Power/Mode Selection Button for 3 seconds.
not turn on
• If the milk, room temperature and ml/oz symbols are flashing, then the lid has not been closed correctly.
• If all volume symbols are flashing, and the warmer beeps intermittently for 30 seconds then the cycle is
Symbols on
the display are
• If all mode and starting temperature symbols are flashing, then the unit requires de-scaling. See section
flashing
• If ml/oz symbols flash, and the warmer beeps twice, insufficient water has been placed in the warmer.
The warmer is
beeping
• If all volume symbols are flashing, and the warmer beeps intermittently for 30 seconds then the cycle is
To stop the
Press the Power/Mode Selection Button and the warmer will beep and return to default settings.
warming cycle
To start the Once the correct mode, starting temperature and volume have been selected, press and hold the Volume
warming cycle Selection/Start Button until the warmer beeps.
If the lid is opened at any time during the warming cycle, the lights on the display panel will flash and
If the lid is
the warmer will stop and return to default settings. In order to reset the warmer after the lid has been
opened during
opened, empty out any residual water, then follow instructions for use from step 1 onwards. Since this
warming cycle
could occur at any stage of the warming cycle, milk or food should be discarded for safety reasons.
Difficulty
setting the
appropriate The maximum volume that may be selected when warming food from frozen is 230ml/8oz.
amount of
frozen food
Guarantee
Philips AVENT guarantees that should the iQ Bottle and Baby Food Warmer become faulty during twelve
months from the date of purchase, it will be replaced free of charge during this time. Please return it to the
retailer where it was purchased. Please keep your receipt as proof of purchase, together with a note of when
and where purchased. For the guarantee to be valid, please note:
• The iQ Bottle and Baby Food Warmer must be used according to the instructions in this leaflet and connected
to a suitable electricity supply.
• The claim must not be a result of accident, misuse, dirt, neglect or fair wear and tear.
This guarantee does not affect your statutory rights.
complete. Follow Step 8 onwards to remove the bottle or container from the warmer.
'Care of your iQ Bottle and Baby Warmer' on page 6. To acknowledge the de-scale warning, press and hold
the Power/Mode Selection or V olume Selection/Start Button for 3 seconds. If you do not wish to de-scale,
please be aware that this may cause irreparable damage.
Unplug the warmer, discard the milk or food and empty any remaining water. Be careful as the warmer is
hot. Follow instructions from Step 1 onwards.
complete. Follow Step 8 onwards to remove the bottle or container from the warmer.