Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.3 Packaging contents
The Panel Chain counter IRIS II packaging includes:
1 Panel Chain counter (with seal & closure cover)
1 Magnetic sensor
1 Magnet for the windlass
1 Connector 10-pole with crimp-type female contacts
2.4 Connector diagram
3 INSTALLATION
Recommended accessories
Use exclusively original Lofrans accessories and spare parts, designed and manufactured to ensure performances, duration and for
keeping valid the warranty. For information on available spare parts, contact your local reseller or visit website www.lofrans.com
3.2 Installing the magnetic sensor for horizontal shaft anchor windlasses
(see Fig. 2A – 2B – 2C)
Drill a 4 mm (~3/16") hole in the cover through which to
thread the sensor cable. Fasten Part A of the support
with the two screws provided, after having positioned
the O-ring in the lower part of the support. Cut Part
C to measure using a hacksaw. The sensor must be
positioned at a distance of about 3 mm (~1/8") from the
magnet. Fit Part C with the magnetic sensor on support
A and fix it in place using an adhesive for plastic (two-
component epoxy glue) or silicone. Using the same glue,
attach the sensor to Part C.
4
3.1 Installing the magnet on the anchor windlass
On a few models of anchor windlass the sensor and the magnet are already
installed (chain counter setting).Therefore, the operations described below are
not necessary.
1. A hole having a diameter of 6.5 mm (~1/4") and depth of 8 mm (5/16") must be drilled
on a tooth of the gipsy, in a place outside the chain's path.
2. In the case of horizontal shaft anchor windlasses (see Fig.1), drill the hole in the outer
circumference of the gipsy.
3. Also make sure that the protruding part of the magnet will not collide with the base or
sensor during rotation of the gipsy.
Insert the metal part of the magnet in the hole, allowing the protected part to protrude by
about 2 mm. Fix it in place using an adhesive for metals (two component epoxy glue) or
Fig. 1
silicone. The glue used must be able to withstand a marine environment.
4 Mounting screws 3.5 x 13 mm
1 Sealing rubber flange
1 Horizontal shaft anchor windlass sensor support
1 Installation and user's manual
.
.
10 -POLE REAR CONNECTOR
PIN
SIGNAL
1
+ battery
2
N.C
3
- battery
4
N.C
5
N.C
6
UP command
7
DOWN command
8
N.C
9
N.C
10 Magnetic sensor
r
a
t
a
t
r
Part. C
Part.
a
r
r
a
IRIS II
. C
Publicidad
Capítulos
Tabla de contenido
