Ordering Information - Pima WRN Instrucciones De Instalación

How to mount and connect the WRN
1. Insert a slotted screwdriver to the niches at the bottom of the receiver and remove the backplate.
2. Pass the four bus wires (not supplied) through the backplate and mount it on a flat surface.
3. Connect the bus wires using the supplied connector, making sure to follow the numbering on both the control panel's KEYPAD
terminals and the receiver (terminal #1 on the control panel connects to the same terminal on the receiver, etc.).
4. Close the enclosure.
5. Set the receiver in the control panel.
6. Test the receiver.
The LEDs
LED label Color and state
Green solid
RUN Green blinking
Off
Red solid
DATA Red blinking
Off
Red 1 blink
Red 2 blinks
FAIL Red 3 blinks
Red 4 blinks
Off
Rx Red 1 blink
VALID Green 1 blink

Ordering Information

 WRN143 P/N: 8500036
Description
Voltage OK
Voltage fault
Receiver fault or power loss
Bus communication fault
Bus communication OK
Wiring fault
Invalid frame received
Receiver not receiving signals from the control panel
(possible loose connection in the bus's wire no. 4)
Control panel not receiving signals from the receiver
(possible loose connection in the bus's wire no. 3)
Fatal communication error
No fault exists
Unregistered peripheral received
Registered peripheral received
 WRN187 P/N: 8500037
-2-