Ordering Information - Pima WRB Serie Instrucciones De Instalación

How to mount and connect the WRB
Mount the receiver on a flat surface. Follow the next steps.
1. Insert a slotted screwdriver to the two niches at the bottom of the receiver and remove the backplate.
2. Pass the four bus wires (not supplied) through the backplate and mount it on a flat surface.
3. Connect the bus wires using the supplied connector. Connect the wires according to the numbering on both the control panel
and the receiver's terminals (no. 1 on the control panel connects to no.1 on the receiver, etc.).
4. Set the receiver in the control panel (see how in the FORCE's Installation guide) and check the LEDs; see below.
5. Click the receiver into the back plate.
6. Test the receiver using the
The LEDs
Label Color and state
Run Green 1 blink
Bus Red 1 blink
Red 1 blink
Rx
Red 2 blinks

Ordering Information

 WRB143 P/N: 8500038
Tests and Diagnostics menu.
Description
Receiver OK
Valid communication (FORCE bus)
Reception - unregistered peripheral
Reception - registered peripheral
 WRB187 P/N: 8500039
-2-