Energy-Saving Tips; Installation - Summit SPR6-OS Manual De Instrucciones

Energy-Saving Tips

Do not place your refrigerator next to a heating vent, a range or in direct

sunlight.
Keep the door closed as much as possible, especially in hot, humid weather.

Cover foods to reduce moisture buildup inside the appliance.


Installation

This refrigerator is designed for free-standing installation only. It has a fan at the
bottom of the unit to direct compressor-generated heat away from the compressor
and through vents in the back of the unit. The airflow from the vents at the back of
the system must be unimpeded. Allow a minimum clearance of 4" at the back of
the unit to ensure proper air circulation. Once the unit is positioned, the leveling
legs should be turned to level the refrigerator. Installation should be such that the
cabinet can be moved for servicing if necessary.
If you wish the unit to be mobile, the four supplied rolling casters can be attached
to the bottom of the unit. These casters can be locked into place when the
refrigerator is in the desired location.
The door handle is connected to the left edge of the door with four screws.
To reverse the door opening, use a Phillips-head screwdriver to remove the
handle from the left edge of the door, and then screw it onto the right. It will be
necessary to switch the locations of the upper and lower door hinges. To do this,
follow these steps:
1. Remove the screw on top of the refrigerator that holds the triangular
hinge cover, using a Phillips screwdriver.
2. Remove the two hex nuts holding the upper hinge bracket to the top of
the refrigerator, using an adjustable wrench or a 5/16" hex socket driver.
Lift off the bracket, being careful not to lose the small black gasket on
the hinge pin.
3. Lift the door off the lower hinge bracket and tilt the refrigerator
backwards.
4. Unscrew the lower hinge bracket using the 5/16" hex socket driver.
Screw it firmly into the corresponding screw holes on the opposite
corner of the unit.
5. Set the refrigerator back on its feet and remove two black rubber plugs
from the corner of the upper surface. These plugs should be placed
5