Make Electrical Connections - Kohler ProFlex Serie Guia De Instalacion

Optional In-line Heater
(models may vary) either
T-style (shown) or water
intake (not shown)
Bond in accordance
with applicable codes

9. Make Electrical Connections

WARNING: Risk of electrical shock. To reduce the risk of electrical shock, connect the pump and in line
heater to properly grounded, grounding type receptacles protected by Ground Fault Circuit Interrupters
(GFCI's). Do not remove the plugs' grounding pins. Do not use grounding adapters.
Pump Wiring
NOTE: The whirlpool model number is printed on a label near the whirlpool pump. This label also identifies the
electrical rating of the whirlpool.
- Your Kohler whirlpool bath is equipped with a cord and plug. All wiring of the pump and control has been
completed at the factory. A licensed electrician must install a GFCI protected, 120 V, 15 A, grounded outlet. No
other load should be on this circuit. Locate the outlet behind the whirlpool, and within 24" (61cm) of the pump.
- Plug the pump into this outlet.
NOTE: Make sure the air actuator tubing is securely attached to the pump, and is not kinked or damaged.
- If a K 1639 Timer Kit will be used, install it now according to the instructions packed with the timer kit.
In-line Heater Wiring
- H" Models: The in line heater is equipped with a cord and plug. All wiring of the heater has been completed at
the factory. A licensed electrician must install a GFCI protected, 120 V, 15 A, grounded outlet. No other load
should be on this circuit. Locate the outlet behind the whirlpool, and within 24" (61cm) of the heater.
- Plug the in line heater into the outlet.
Kohler Co.
Plug the in-line heater into
this outlet
9
Plug the pump into this outlet
Install a GFCI-protected 120 V,
15 A grounded outlet. Install a
second GFCI-protected outlet
for "H" models for the in-line
heater.
Make sure air actuator tubing is
securely attached to the pump or
the optional time box
1011090-2-
B