Fullyd Ucted; Typical Installations; Ystem; Central Draw Point - Broan HRVH100S Guia De Instalacion

2. T I
YPICAL NSTALLATIONS
Use the following illustrations as guidelines to help you decide on how the unit will be installed.
All the units should be hung from the joists.
In every case, bathroom fans and a range hood could be used to exhaust stale air. Also, for homes with more than one level, we recommend
one exhaust register at the highest level.
There are 3 installation methods: Fully Ducted System, Central Draw Point and Simplified Installation.
NOTE: An electrical outlet has to be available within 3 feet of the unit.
2.1 F D S
ULLY UCTED

YSTEM

Stale air coming from the register located at the highest level of the
house is exhausted to the outdoor. Fresh air from outdoor is filtered and
supplied by the register located in the lowest liveable level.
Homes with more than one level require at least one exhaust register at
the highest level.
See figure at right.
2.2 C D P
ENTRAL RAW
Stale air coming from the register located at the highest level of the
house is exhausted to the outdoor. Fresh air from outdoor is filtered and
supplied to the return (plenum) or the supply duct of the forced air unit.
See figure at right.
For this type of installation, it is not essential that the forced air system
blower runs when the unit is in operation, but we recommend it.
NOTE: Home with multiple forced air systems should have one unit on
each system.
2.3 S I
IMPLIFIED NSTALLATION
Stale air is exhausted to the outdoor. Fresh air from outdoor is filtered
and supplied to the return (plenum) or the supply duct of the forced air
unit.
See figure at right.
To avoid cross-contamination and achieve the highest efficiencies, the
forced air system blower must always be ON.
NOTE: Home with multiple forced air systems should have one unit on
each system.
(P
RIMARILY FOR HOMES WITH RADIANT HOT WATER OR ELECTRIC BASEBOARD HEATING
(C
OINT ONNECTION TO A FORCED AIR SYSTEM
(C
ONNECTION TO A FORCED AIR SYSTEM
VH0024
)
VH0025
)
VH0093
4
)