Information About Radio Operation; Maintenance And Cleaning; Technical Characteristics; Intended Use - Xavax MAX! Cube Manual De Operación

1.10. Information about radio operation

Radio transmission is performed on a non-exclusive transmission path, which means that there is a possibility of inter-
ference occurring. Interference can also be caused by switching operations, electrical motors or defective electrical de-
vices. The range of transmission within buildings can differ greatly from that available in the open air. Besides the trans-
mitting power and the reception characteristics of the receiver, environmental factors such as humidity in the vicinity have
an important role to play, as do on-site structural/screening conditions.

1.11. Maintenance and cleaning

The product does not require any maintenance. Enlist the help of an expert to carry out any repairs. Clean the product
using a soft, lint-free cloth that is clean and dry. You may dampen the cloth a little with lukewarm water in order to remove
more stubborn marks. Do not use any detergents containing solvents, as they could corrode the plastic housing and label.
Disconnect the device from the power supply system before commencing cleaning.

1.12. Technical characteristics

Power supply:
Housing dimensions (W x H x D): 80 x 80 x 80 mm
Radio frequency:
Receiver class:
Degree of protection:
Typical open air range:
Interface:
Colour:
Subject to technical changes.
2. Window Sensor

2.1. Intended use

The MAX! Window Sensor signals when windows or doors are opened and closed. As part of the MAX! System, it thus
ensures that MAX! Radiator Thermostats automatically reduce the temperature when a window or door is open (to save
energy) and increase it again when the window or door is closed. The reduction temperature can be set separately for
each room in the MAX! Software.
The device may only be operated indoors and must be protected from the effects of damp and dust, as well as solar or
heat radiation. Using this device for any purpose other than that described in this operating manual does not fall within
the scope of intended use and shall invalidate any warranty or liability. This also applies to any conversion or modification
work. This device is intended for private use only.

2.2 Overview

(1)
(1)
Magnet with spacers
(1+2) Window sensor
(2)
Electronic unit
The device is supplied with spacers and caps in white and brown
00111932man_de_en_es_fr_nl.indd 13
Input: 100 V - 240 V~ / 350 mA
Output: 5 V= / 550 mA
868.3 MHz
SRD Class 2
IP20
100 m
RJ-45 (Ethernet)
White
(1+2) (2)
13
13.07.11 14:27