Safety Notices; General Information; Iii.package Content; Installation Of The Ethernet/Ip Kit - WEG EtherNet/IP Fieldbus Guia De Instalacion

Installation, Configuration and Operation Guide
ETHERNET/IP
I. SAFETY INFORMATION
ATTENTION!
- Make sure the incoming power supply is disconnected before installing any additional
components on the drive.
- Many components may remain charged with high voltages even after the incoming
power supply has been disconnected. Wait for at least 10 minutes before touching any
electrical component.
II. GENERAL INFORMATION
This manual guides you through the installation and operation of the
Fieldbus Kit (KFB-EN)
III. PACKAGE CONTENT
The KFB-EN kit is composed of the following items:
Quantity
1 EtherNet/IP Anybus-S Communication Board.
150mm Ethernet Cable (Cat5e).
1
1
Plastic Spacer.
M3x6mm Male/Female Metal Spacer.
1
1 RJ45 Ethernet Connector.
M3 Hexagonal Nut.
1
1 M3 Flat Washer Zinc.
M3x5 Philips Screw with Pressure Washer.
1
1 Metal Parts for support/closing (size 1, size 2, and sizes 3 to 10).
Floppy Disk containing the configuration file.
1

1. INSTALLATION OF THE ETHERNET/IP KIT

The communication board that is part of the KFB-EN kit is directly installed on the CC9
control board, connected to the XC140 connector, and supported by spacers as presented
in Figure 1.
Metal
Spacer
Washer
Nut
Figure 1: Installation of the Communication Board
FIELDBUS KIT
. It applies to Ethernet/IP .
AA View
A
(KFB-EN)
Description
EtherNet/IP Board
CC9 Board
M3x5 Screw
A
EtherNet/IP
1