A.
B.
E.
KEY
A. Safety Lock
F.
C.
B. See safety instructions
C. Pull-out bin
D. Casters
E. Paper/card entry
D.
CAPABILITIES
Will shred: Paper, staples and credit cards
Will not shred: CD/DVDs, adhesive labels, continuous form paper, transparencies,
newspaper, cardboard, paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper/card shred size:
Micro-Cut .....................................................................................................3mm x 10mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set
to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse (
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 7-minutes maximum
NOTE: Shredder runs briefly after each pass to
Plug in and set to
clear entry. Continuous operation beyond 7-minutes
Auto-On (
)
will trigger 60-minute cool down period.
Safety Lock prevents accidental operation.
To set, wait for shredding to stop, set control switch to Off (O) position, then slide black button down.
To unlock, slide black button up. For greater safety, always unplug shredder after use.
2
62MC_407929_18L_012314.indd 2-3
62MC_407929_18L_012314.indd 2-3
F. Control Panel and LEDs
1. Reverse
To set lock slide
button down
2. ON/OFF (green)
3. Forward
4. Overheat (red) and
Remove paper (yellow)
5. Bin open (yellow)
Maximum:
Sheets per pass ........................................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 223mm
* A4 (70g), paper at 220V-240V, 50/60 Hz, 2Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 150 sheets
per day; 10 credit cards
10 sheets per pass to avoid jams.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
) to back out object.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
2
3
When finished shredding,
Feed paper/card
straight into paper
set to Off ( )
entry and release
ENGLISH
PRODUCT MAINTENANCE
Model 62MC
OILING SHREDDER
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
*Apply oil across entry
Press and hold forward
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
TROUBLESHOOTING
PAPER JAM
1
2
Set to Reverse (
)
Alternate slowly back and forth
for 2-3 seconds
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, press reverse (
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
3
4
5
6
Set to Auto-On (
)
Set to Off ( )
Gently pull uncut
and resume shredding
and unplug
paper from paper
entry. Plug in
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
for any consequential or incidental damages attributable to this product. This warranty gives you
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
except where different limitations, restrictions, or conditions may be required by local law. For
more details or to obtain service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Make sure switch is in on position ( ).
Make sure safety lock is in unlock position.
Make sure bin is closed.
Check for jam.
Remove and empty bin.
Wait 60 minutes for motor to cool down.
3
2/3/14 1:28 PM
2/3/14 1:28 PM