Installing Batteries - Cedar Ridge CRHSD25RTA Manual De Instalación Y Funcionamiento Del Propietario

4. Place pins on log #4 into holes to the left
of the burner as shown in Figure 13, page
14 and Figure 15.
5. Place pins on log #8 into holes to the right
of the burner as shown in Figure 13, page
14 and Figure 15.
6. Place pin on log #5 into hole in the left side
of log #1 as shown in Figures 15 and 16.
Hole for Log #5
Log #4
Figure 15 - Logs #4 and #8
CAUTION: Do not mix old and
new batteries. Do not mix alka-
line, standard (carbon - zinc), or
rechargeable (nickel - cadmium)
batteries. Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Install/replace the batteries according to the
type and quantity stated in table below.
• Do not mix old and new batteries. New bat-
teries should be the same brand for best
results.
200125-01B
INSTALLATION
Hole for Log #7
Log #8

INSTALLING BATTERIES

www.usaprocom.com
7. Place log #6 into cutouts in log #1 and log
#2 as shown in Figure 16.
8. Place pin on log #7 into hole in the right side
of log #1 as shown in Figures 15 and 16.
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Log #6
Log #5
Figure 16 - Logs #5, #6 and #7
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installation
may void the warranty on the product.
• For remote control systems, maximize bat-
tery life by turning off the receiver when it
is not in use.
• For long periods of non-operation, remove
batteries from all components for safety.
Component
Ignitor
Remote Control
Remote Receiver
*Note: Quantity depends on model of remote
control.
Log #7
Type of Battery Qty.
AAA
AAA 2 or 3*
AA
1
4
15