ALDI 46857-15 Manual Del Usuario página 7

STUD FINDER
The device can be used to detect the following objects (materials):
– Wood/joists (STUD), maximum detection depth 19 mm
– Metal (METAL), maximum detection depth 30 mm
– Electric lines (AC), maximum detection depth 50mm
– With the DEEP setting, particularly deep-seated joists/wood and metal items can
be detected (max. detection depth 38 mm)
Select mode
– Press the MODE button in order to select the required mode
STUD METAL AC
Start search
Calibrating the device to the object
Prior to each search procedure, a calibration of the device takes place.
Hold the device still, with its reverse side against the surface in which you are
searching for the searched object and keep the calibration button pressed down, until
a bar cannot be seen on the LC display. Press the calibration button (4) and keep the
button pressed down. After approx. 2 seconds, three short beeping tones will sound.
The calibration is completed and the search procedure can begin.
Note:
– During the calibration, the device must be held still and must not be moved.
– If you calibrate too closely to the object or directly on the wood, the calibration
can fail. If the calibration should fail, the LC display will show the following symbol
" " or a long beeping tone will sound. Then, please switch the device on again,
in order to start the calibration. This time, please hold the device several centime-
tres further right or left from the previous surface. The calibration button must be
kept pressed during the entire search procedure and the device must be touching
the surface.
AFTER SALES SUPPORT
1 866 558 8096
DEEP
MODEL: 46857-15 PRODUCT CODE: 46857
OPERATION
7
service@eurocentra.net
03/2015