shada 2400340-1 Manual De Operación / Instalación Y Especificaciones página 4

Operation of daylight sensor
1. During remote control settings, press the
2. Change the lux value
3. Change the lux value
4. Press to save the settings
5. Press to send the stored setting to the sensor, the product that contains the sensor will blink 1x
to confirm receipt.
Note! Note!
This feature is turned off by default and can only be changed when you press the This feature is turned off by default and can only be changed when you press the
view. view.
During activation of this setting, only a standby dim time of indefinite time is possible. During activation of this setting, only a standby dim time of indefinite time is possible.
See image 02 for clarification of this function. See image 02 for clarification of this function.
Corridor fuction (img.02)
This is a 3step dimming function within the sensor and works as follows:
1. Lamp is off because there is enough ambient light (even if motion is detected).
2. If there is less ambient light than the set lux value
the selected brightness level (brightness %) and stays on as long as it detects movement.
3. When the product detects no movement anymore and the selected hold time expires, it switches to
standby mode (set "standby" time and dimming level)
4. After the selected "standby" period elapses, the product will turn off.
Corridor fuction (img.02)
With sufficient natural light, the light
does not switch on, even when
presence is detected.
Difference between Daylight sensor mode and corridor mode Difference between Daylight sensor mode and corridor mode
The difference lies in turning on and off. In the corridor mode, the sensor will trigger (turn on) the product The difference lies in turning on and off. In the corridor mode, the sensor will trigger (turn on) the pr
whenever motion is detected, while in the daylight sensor mode the amount of light determines when to trigger whenever motion is detected, while in the daylight sensor mode the amount of light determines whe
the product. In the daylight sensor Mode, the product will therefore turn on when it gets dark, even though the product. In the daylight sensor Mode, the product will therefore turn on when it gets dark, even
there is no movement detection. See image 03 and 04 for a graphic explaining the difference. there is no movement detection. See image 03 and 04 for a graphic explaining the difference.
icon to activate the additional daylight mode.
to set when the product should turn on during the day.
to set when the product should automatically go out.
With insufficient natural light, the
sensor switches on the light automat-
ically when presence is detected.
then the product will turn on at
When no presence is detected any-
more and after the hold-time expired,
the light dims to stand-by level if the
surrounding natural light is below the
daylight threshold.
button during settings button during
Light switches off automatically after Light switches off a
the stand-by period the stand-by period
elapses. elapses.
EN EN
DE
NL
FR
ES