john deer ET-3409-J Manual De Instrucciones página 6

FOR YOUR OWN SAFETY READ THIS INSTRUCTION MANUAL BEFORE OPERATING THE TABLE SAW
1. Always wear eye protection when using the table saw.
2. Always use saw blade guard and spreader for every operation for which it can be used, including all through
sawing.
3. Always keep hands out of the path of the saw blade.
4. Always use a push stick when required.
5. Pay particular attention to instructions on reducing risk of kickback.
6. Never perform any freehand operation with the table saw.
7. Never reach around or over the saw blade.
ALWAYS REMOVE ADJUSTING KEYS AND WRENCHES BEFORE STARTING TOOL
Always confirm that all keys and adjusting wrenches have been removed from the tool before it is turned on.
NEVER FORCE THE TOOL
It will do the job better and more safely if it is operated at the rate for which it was designed.
ALWAYS USE THE RIGHT TOOLS
Never force a tool or an attachment to do a job for which it was not designed.
ALWAYS MAINTAIN TOOLS WITH CARE
Always keep tools sharp and clean for the best and safest performance. Always follow instructions for lubricating
the tool and for changing accessories.
ALWAYS USE RECOMMENDED ACCESSORIES ONLY WHEN OPERATING THIS TOOL
Consult this instruction manual for descriptions of recommended accessories. To avoid personal injuries, use only
recommended accessories in conjunction with this tool.
ALWAYS CHECK FOR DAMAGED PARTS BEFORE USING THE TOOL
Always check the guard and all other components for damage before using the tool to assure that they will function
properly. Check all moving parts for proper alignment, free from binding and other conditions that might affect
proper operation. Always repair or replace any damaged guards or other damaged components before using the
tool.
ALWAYS CONFIRM THE ROTATION DIRECTION OF THE BLADE BEFORE USING THE TOOL
Always feed work into the tool against the rotation direction of the blade in order to prevent possible injury.
PROPER GROUNDING
This tool should be grounded while in use to protect the operator from electric shock.
This tool was not designed to be used for mass-production applications and should not be used in mass-produc-
tion environments.
When servicing this tool, use only authorized replacement parts.
Apply 115 volts AC only to this tool. Applying the wrong voltage or applying DC power can cause the POWER
TOOL to operate improperly and cause serious personal injury or damage the tool.
6
WARNING
CAUTION
Table Saw Operator's Manual