Installation; Base Installation; Door Handle Installation - Conglom QL100 Manual Del Usuario

Installation

BASE INSTALLATION

- Remove the utility sink (D) and place it on a soft, protective
surface .
- Turn the cabinet (A) upside down onto the protective surface .
- Attach the cabinet base (C) onto its proper location . Using the
supplied base screws (BB), attach the base to the cabinet .
- Attach leveling feet (G) to the base .
- Gently rotate the cabinet (A) right side up .
- Place a carpenter's level on top of the cabinet, then adjust each
leveling foot until the cabinet is level .

DOOR HANDLE INSTALLATION

- Insert the door handle screws (AA) into the pre-drilled holes on
each door .
- Attach the door handle (H) and hand tighten the door handle
screws (AA) .
- Repeat on other door .
QL100
CAUTION:
Do not rest or bump the leveling feet on the side
as this may cause them to detach or break .
BB
A
6
C
G
AA
H