Mounting The Utility Sink; Placement; Drainage; Supply Line - Conglom QL100 Manual Del Usuario

Installation (continued)

MOUNTING THE UTILITY SINK

- Carefully place a bead of sealant all around the top of the
cabinet (A) .
- Ease the sink (D) into the cabinet (A) . Ensure that it is
placed evenly and is centered on the cabinet . Wipe off any
excess sealant . Use masking tape to hold the sink in place
until the sealant dries .

PLACEMENT

Position the cabinet in the intended location . If required, level the cabinet by adjusting the four leveling legs and checking the alignment of
the top using a carpenter's level . Secure the cabinet to the wall if necessary .

DRAINAGE

The tailpipe (not supplied) previously installed to the drain can now be connected to your household plumbing . In some cases, your household
plumbing will have to be modified to ensure proper drainage. If so, please consult a licensed plumber to complete needed modifications.
SUPPLY LINES (NOT INCLUDED)
Connect the supply lines to your home's water supply as per manufacturer's instructions .
Open the hot and cold water supply valves and check to make sure they have
been installed to appropriate inlet ports . Check for leaks . Run hot and cold water
uninterrupted for about one minute to remove any residue from the lines .
9
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
CONGLOMKB .COM