Troubleshooting - Parrot PARTY Manual De Instrucciones

TROublEShOOTING

Problem
No sound is coming through
the Parrot PARTY.
I cannot connect my audio player
to the Parrot PARTY.
The centre LED on the Parrot
PARTY is red.
18
Solution
- Ensure that the device is
switched on (ON/OFF switch
on the back of the device) and
sufficiently powered.
- Check that your device supports
the Bluetooth A2DP profile and
the source role.
- Hold down the Configuration
button on the Parrot PARTY for
two seconds, then restart
the search and connect.
- The red colour means that the
battery level is low (battery life is
less than 15 min). Plug the Parrot
PARTY into the mains: the LED
turns violet to indicate that the
device is being charged and then
turns blue once the battery has
been fully recharged.
Parrot PARTY
I used a Jack audio cable - Check that the jack audio cable
to connect my audio player, is properly plugged in to the Parrot
but I get no sound. PARTY and audio player.
- Check that there is no Bluetooth
connection with an audio player.
The Bluetooth connection will take
priority over the Jack connection.
My Parrot PARTY makes - Check that the jack audio cable
a noise when I use is properly plugged in to the Parrot
a jack audio cable. PARTY and audio player.
I am using my PC as - Check that the «Sound
a Bluetooth audio player, playback» option is set to «High-
but there is no sound coming quality Bluetooth Audio».
from my Parrot PARTY. You can find this option
by selecting Start/Settings/Control
panel/Sound and Audio Devices/
Audio on your computer.
When I watch a video, the - Use the Parrot Audio
sound from the Parrot PARTY Configuration Tool to check
is not synchronised with the that your system's audio delay
image. is correctly configured
for this type of use.