GMC GHT26 Manual De Instrucciones página 10

General inspection
• Regularly check that all the fixing screws are tight
• Inspect the fuel tank and lines of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised GMC service centre. This advice
also applies to extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the machine's service life. Clean the body of your machine
with a soft brush, or dry cloth. If available, use clean, dry, compressed air to blow
through the ventilation holes
GB
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use
alcohol, petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Preparation for long-term storage
• Whenever the hedge trimmer is out of use for an extended period of time, proceed
as follows:
1. Give the unit an overall cleaning and a thorough check
2. Clean the air filter element
3. Drain the fuel system
4. Remove the spark plug, fill about a spoonful of 2-stroke oil into the cylinder through
the spark plug hole, and pull the Recoil Starter (9) gently two to three times to
distribute the oil evenly. Replace the Spark Plug
5. Slowly pull the Recoil Starter just until resistance is felt. At this point, the piston is
coming up on its compression stroke, and both the intake and exhaust valves are
closed. Storing the engine in this position will help prevent internal corrosion
6. Protect all metal parts from corrosion by coating them with oil or a machinery
preservative
Storing fuel
• Store 2-stroke mix ONLY in containers specifically designed for fuel storage
• Store fuel in a dark place with a constant, low temperature
Disposal
Always adhere to national regulations when disposing of power tools that are no
longer functional and are not viable for repair.
• Tools powered by petrol-based internal combustion engines must not be disposed
of with household waste. Such tools should be taken to your local recycling centre
and disposed of according to current environmental protection requirements in
your country.
• Petrol, oil and petrol-oil-mixtures are hazardous waste and have to be treated
as such. Oil and fuel must not be disposed of with household waste. Improper
disposal may be regarded a criminal offence in your country. Contact your local
authority or dealer for correct disposal procedures for oil and old fuels.
10