Quick Setup - ION Shutter Pal Guia De Inicio Rapido

Quick Setup

After pairing your smartphone to Shutter Pal and
launching your smartphone's default camera app,
follow these steps to connect the monopod to your
smartphone.
1. Insert your smartphone into the smartphone
clamp. Use the included insert if you have a
smaller size smartphone.
2. Connect
monopod screw and tighten using the rotary
wheel.
3. Adjust the position of the mount and tighten
using the side knob.
4. Adjust the size of the monopod.
5. Press the Camera button on Shutter Pal to take
your photo.
Note: The included smartphone clamp can be used
as a mini stand for your smartphone when detached
from the monopod. In this situation the monopod
becomes a remote trigger for your smartphone.
Note: If Shutter Pal is powered on and not used for 5
minutes, it will go to low-power mode (sleep). To
wake up Shutter Pal, press the Camera button on
Shutter Pal.
Note: Using your smartphone's default video app,
you can use Shutter Pal to capture video over
crowds at concerts or in difficult to reach places.
the smartphone clamp to the
4