Publicidad
4.9 CONEXION DE ABREPUERTAS DE CORRIENTE ALTERNA.
CONNECTION OF ALTERNATING CURRENT DOOR-OPENER.
Alternating current door opener (12 Vac, max 1A)
5. DISEÑO DE INSTALACIONES: SECCIÓN CABLES Y FUENTES DE ALIMENTACIÓN.
DESIGN OF INSTALLATIONS: CABLE CROSS SECTION AND POWER SUPPLIES.
The UTP cat.5 cable consist of 4 twisted pairs and is protected
fron interference. In making the entire facility with UTP cable, turns
out to be an option cheap and easy to install.
The distribution of video is made by distributors M1924. In the
vertical wiring, 3M circulates for one pair of UTP cable, while in
the horizontal wiring does it by a single wire. The other wire of the
pair is used to feed the video distributor (terminal block 14). The
terminal block 2 (ground) of the distributor it connects to the pair
2M. Remember thet the terminal blocks 14 of the distibutors should
not connect with each other.
Digital audio control units G3230 and G3240 are ready for the
connection of alternating current door openers. The connection
between the street panel and the door opener is executed in a
different manner and a F1318 power source will have to be added.
It will be possible to activate 12VAC alternating current and 1A
maximum current door openers with this configuration.
The schematic found below details the connection between the
street panel’s digital audio unit, F1318 power source and the
alternating current door opener:
The activation time of the door opener when the external push
button is activated is not in timer mode; that is to say, the door
opener can only be activated when the external push button is held
down.
next to each Street panel.
general tables
that of one Block or Internal Bus.
Auxiliary door opener push-button
F1318
simplified tables
a Power Supply
General Installation Guide
Technical Assistance Service
"No. of Dwellings" is
Publicidad
