Matrix KS 200-1 Traducción Del Manual Original página 23

the arrow on the cover.
Only use discs which are suitable for a minimum
speed of 7500 rpm.
After the disc has been repaired or replaced it
must be able to rotate freely. Do not use any
discs that vibrate or are oval.
Do not move the chain with your left hand when
the machine is operating.
Do not stop the disc with your hands or other
objects.
Be careful when handling the chain teeth on the
saw chain if the machine is operating. They can
cause serious lacerations.
Machine components (B1-B2)
1. Mains cable
2. Handle
3. ON/OFF switch
4. Machine base frame
5. Machine head
6. Bolt for machine head
7. Depth stop
8. Grinding disc
9. Disc guard
10. Graduated scale for grinding angle
11. Locking screw for grinding angle
12. Chain guide
13. Locking screw for chain guide
14. Adjustable stop
15. Adjusting screw for stop
16. Grinding disc direction of rotation
17. Stop bolt
Assembly
Check the contents of the packaging to ensure
they are complete and have not suffered
transport damage before assembly.
The machine must be securely bolted to a
workbench on the machine base frame (4).
Use two bolts for this purpose which are long
enough to secure the machine properly to the
workbench (B3-B6).
The machine operator must stand parallel with
the workbench and machine and push the
handle (2) of the machine down whilst the links
of the saw chains are being sharpened.
Only connect the machine to electricity supplies
whose mains voltage is the same as that set out
on the model plate.
Carry out the following checks before you switch
on the machine. Switch off the machine and pull
the mains plug for this purpose.
1. Condition and profile of the grinding disc (8).
2. Condition of the power cable (1).
3. Check whether the machine is also correctly
secured to the workbench (B6).
4. After the machine has been connected to the
power supply and switched on, first check
whether the disc (8) runs true. The disc (8) may
have to be replaced if it does not run true.
Starting
After the preparatory checks have been
completed and additional safety equipment has
been attached, carry out the following work:
- Connect the machine to the power supply.
- Position the chain (B7) - (B14).
- Start the machine by moving the ON/OFF
switch (3) to "I".
- Sharpen the chain.
Stopping
When you have finished all the work, carry out
the following steps to switch off the machine
23