Gate Operators - Chamberlain KLIK3U Manual De Instrucciones

GATE OPERATORS

Programming to a Gate Operator with a LEARN Button
The LEARN button is typically located on the control board of the operator or an external receiver. For help locating your LEARN
button contact your gate operator manufacturer.
The images throughout this manual are for reference only and your product may look different.
1
Press the program button on the remote control until
the LED turns on.
LED
Program Button
3
Press and release the remote control button, the LED will
flash. When the LED stops flashing, continue to press
and release the button until your gate operator responds
by clicking, blinking, or activating.
5
Test the remote control by pressing the button. If the gate operator does not activate, repeat the programming steps or follow
the alternative programming option.
2
Press and release the LEARN button* on your gate
operator.
* Depending on your product, the LEARN button may have a different name (use
the button for programming remote controls).
4
Press the program button on the remote control to save.
Program Button
6
Learn Button*