Programmable Digital Voltage Source With Enable Switch - DART Controls DP4 CONTROL Serie Manual De Instrucciones

Parameter Confi guration:
Parameter Value
10 3
12 2
13 3
18 1
20 120
21 120
22 0
25 0
26 1000
27 500
35 3
36 50

Programmable Digital Voltage Source with Enable Switch

Description:
A test stand needs an easily adjustable and accurate 0 - 5VDC signal to test the response of
a device under test. The digital display of the voltage source (DP4) should read in 1/100ths of
a volt (V.VV). When the unit initially has power applied, it should always default to an output
voltage of zero volts. When the output is greater than 0 volts, an illuminated alarm should light
and fl ash to indicate that the device under test is being actuated.
Application Diagram:
Enable Switch
Enable Disable
Output mode set to rate bipolar to support +/-10V regenerative drive
Zero-blanking set to 2 digits
Decimal point position set to XXX.X on display
Power-up display value set to default at 0.0
Display minimum set to -12.0
Display maximum set to 12.0
Display center set to 0.0
Set output minimum to 0% (-10V)
Set output maximum to 100% (+10V)
Set output center to 50% (0V)
Input S2 set to force jog when low
Input S2 jog setpoint set to 5.0
D.U.T.
0-5V
Programmable
Output
CONTROLS
Page Neg Rev Ite Valu Fwd Alarm Tach
m
ENTER
3.25
DIGITAL POT
Dart DP4
Notes
Device
Under
Test
20
Pylon-Style
Illuminated
Alarm