Energy Power Bar One Manual Del Usuario página 5

CONNECTION
1. Connecting the soundbar to your TV: The Energy Power Bar One needs to be
connected to your TV, Cable Box or Satellite Receiver. If you have other devices
connected to your TV, such as a DVD/BluRay player, gaming system, etc., connect
the Energy Power Bar One to the TV so that you can listen to all those and your TV
through the Energy Power Bar One. If there are no other devices connected to your
TV other than a cable or satellite box and you receive all of your television programs
from that box, you can connect the Energy Power Bar One to either that box (with
the supplied digital optical cable) or your TV. There are three different ways to con-
nect the Energy Power Bar One to your TV, Satellite or Cable box.
A. 3.5mm/Headphone Output
Once you have placed the Energy Power Bar One where you want it, connect one end of the
3.5mm/Headphone
supplied 3.5mm to dual RCA cable to your TV's 3.5mm/headphone audio output jack and
connect the other end of the cable into the L/R RCA input jacks on the rear of the soundbar.
TV Connection Panel
3.5mm/Headphone
B. RCA Cable
You can use analog left and right audio outputs on your device and connect them to the
analog left and right inputs on the Energy Power Bar One back panel. (cable NOT supplied).
TV Connection Panel
3.5mm/Headphone
3.5mm/Headphone
3.5mm to Male RCA
Cable
(Supplied)
Soundbar Connection Panel
Male RCA to Male
RCA Cable
(Not Supplied)
Soundbar Connection Panel
C. Digital Optical Cable
Since most High Definition TV's, Satellite and Cable boxes have a digital optical audio
output, we have included that cable. Remove the plastic caps on the end of the cable.
Simply connect one end of the cable into the corresponding output of your TV, Satellite or
Cable box and connect the other end of the cable into the digital optical input on the back
panel of the Energy Power Bar One.
NOTE: If you receive any or all of your channels using a separate antenna connected
to your TVs Coax/Antenna input, there may be no sound received from those channels
using the digital optical cable connection.
TV Connection Panel
2. Plug the AC power cord into the soundbar power supply, then connect the power
supply into the DC Input on the rear of the soundbar. Plug the AC power supply into
a "live" electrical outlet and turn the soundbar's Main Power switch on the rear of
the soundbar to "On". On the front of the soundbar, make sure the status light is
either solid green or orange (press any button once if light is steady red).
Power Supply
and AC Cord
PROGRAMMING YOUR TV REMOTE TO OPERATE THE SOUNDBAR
The following 3 steps should be used to program each function of your TV or cable box
remote control buttons (MUTE, VOLUME UP, & VOLUME DOWN). IF THE SOUNDBAR IS IN
STANDBY MODE (solid red status light), push the <SOURCE> button on the soundbar
until the status light is solid GREEN.
Soundbar Front
Control Panel
1. Place the unit in learning mode: With the status light showing solid GREEN, press and
hold down both the <SOURCE> and <MUTE> buttons on the front of the soundbar at
the same time (approximately 3 seconds) until the status light flashes ORANGE.
2. Select the function to learn: Press the <MUTE> button once on the soundbar (the
status light changes to solid ORANGE). (Substitute the VOLUME UP & VOLUME
DOWN in place of <MUTE> when programming the other buttons during this step)
OFF ON
Soundbar Connection Panel
Digital Optical Cable
(Supplied)
Soundbar Connection Panel
STATUS LIGHT
SOURCE
MUTE
VOLUME UP
VOLUME DOWN