Apricorn Aegis Fortress Guía De Referencia Rápida

Aegis Fortress
NOTE: if you are using the Aegis Configurator (sold separately) to set up
your Aegis Fortress, First ensure that the device to be configured has the
CONFIGURABLE
"configurable" logo on the belly label. Also, DO NOT perform the following Manual
Admin and USER PIN SETUP steps below; The Aegis Configurator will only recognize
devices in their factory "out of box" state or devices that have been completely reset.
First Time Use
Before the Fortress can be used, the Admin PIN MUST be set. The LEDs will glow Solid
BLUE and Solid GREEN
To Set-up the Admin PIN:
1. Press + 9 simultaneously. The LEDs will be Constant
2. Enter the new Admin PIN and press the
GREEN
off, the
Blinking GREEN.
3. Re-enter that Admin PIN and press the
glow solidly for three seconds.
4. The BLUE LED will glow solidly indicating the drive is in Admin mode and will remain
that way for 30 seconds or until the
drive to its standby (locked) state.
5. The Admin PIN is now set and will allow access to the drive or the Admin features.
6. To access the drive's data using the Admin PIN, press the
new Admin PIN and press .
Note:
PINs must be a minimum length of 7 maximum 16 digits.
Cannot contain all consecutive numbers (2345678 or 9876543)
Cannot contain all same number (1111111)
The SHIFT key can be used for additional combinations.
SHIFT + 1 are a separate value than just 1.
4
3
2
1
to indicate the Fortress is waiting for an Admin PIN to be set.
LED will blink three times, and then will return to Solid
Quick Start Guide
1
2
3
4
LED Indicator lights
When you first plug in the Aegis Fortress, the unit
will do a self-test to verify all security components
are working properly. The LEDs will go through 3
test stages: RED, GREEN, and BLUE. This will
be followed by three
components are functioning properly. A test failure
will leave the unit in an inoperable state indicated
by a blinking RED LED.
BLUE
key. If accepted, the
key again. If accepted, the
key is pressed, either of which will return the
SHIFT button
UNLOCK button
LOCK button
GREEN blinks indicating all
/ Blinking GREEN.
BLUE LED will turn
BLUE
GREEN
button, then enter the
and
LED will