Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION ADVICE
REMOVE THE MCPHERSON SPRING STRUT
• Before each operation, the McPherson spring strut shall be uninstalled from vehicle by proper means
• Make sure to use the RIGHT SIZE of jaws. Mount on the spring compressor. Make sure the spring is clean where the jaws
are mounted on the windings. Wipe away grease and dirt.
• Fit the retaining bolts and tighten firmly.
• Rotate the drive nut to drive the jaws apart to match the length of the spring and to compress as many windings as possible.
IMPORTANT
It is very important for your safety that the bolts of the jaws are firmly tightened. Check bolt torque (60 Nm) perio-
dically.
• Mount the compressor on a vise by clamping the front head of compressor as below.
• Take care that the seating of the spring windings in the jaws is correct. Spring compressor shall be in the centre of spring
windings (see Figure B).
Figure E
13
Publicidad
Tabla de contenido
