Dri-Eaz HVE3000 El Manual Del Propietario página 7

Remove float ball assembly.
Note: It is not necessary to remove the float ball
assembly to access the pump. However, we recommend
removing the assembly and cleaning it every time you
inspect and clean the pump.
To remove the float ball assembly, loosen lower the
hose clamp on the float ball assembly and remove
assembly.
If you are servicing the float ball assembly, use a Philips
screwdriver to remove the float ball housing retaining
screw and remove the float ball housing. Rinse all
components clean and ensure float ball moves freely
inside housing. Reinstall float ball housing.
Loosen upper pump outlet hose clamp and pull the hose
off the outlet.
07-01782F F479 7 Dri-Eaz Products, Inc.