Publicidad
Idiomas disponibles
Idiomas disponibles
mounTinG wall or CeilinG proDuCT
1. Attach the mounting plate as shown in Figure 1
(mounting screws are NOT supplied). The mount-
ing plate is compatible with the boxes shown in
Figure 3.
2. Connect field wiring to terminals, located on
back of product, as shown in Figure 2.
fiGura 2. wirinG:
–
FACP
INPUT
+
(or Previous Device)
3. To attach product to mounting plate, hook the
tabs on the product housing into the grooves on
the mounting plate shown in Figure 4A.
4. Next,
swing
product
making sure that the tabs on the back of
the product housing fully engage with the
mounting plate and then secure by tighten-
ing the supplied mounting screw as shown in
Figure 4A and 4B. (see Figures 4A, 4B and 4C
on page 2)
5. If the round trim ring is required, it must be
installed before tightening the front mounting
screw. To install, align the round trim ring with
the product housing and push into place. Once
installed, secure the product with the mounting
screw as shown in Figure 5 on page 2.
SS-120-003
NEXT
DEVICE
(or EOL Resistor)
A0435-00
into
position
while
fiGura 3. CompaTible baCk boxeS:
BACK BOX A- 105mm X 105mm
3.7 in.[94 mm]
BACK BOX C- 86mm X 86mm
2.36 in. [60 mm]
BACK BOX E- 4X4
3.38 in. [85.7 mm]
BACK BOX G- 60mmX 60mm
1.77 in.[45 mm]
BACK BOX I- SINGLE-GANG
2
BACK BOX B- 65mm ROUND
2.0 in. [50.8 mm]
BACK BOX D- 4X4
2.6 in. [66 mm]
BACK BOX F- DOUBLE-GANG
1.81 in. [46 mm]
BACK BOX H- 2X4
BACK BOX J- 4 inch OCTAGON
3.50 in. [88.9 mm]
2.47 in. [62.9 mm]
A0434-00
I56-3690-000R
Publicidad
