D-Link DAP-1320 Guía De Instalación Rápida página 7

PRODUCT SETUP
SETUP
SET UP DAP-1320 USING Wi-Fi PROTECTED SETUP (WPS)
NOTE: to connect to a wireless router or ap and extend the Wi-Fi network in your
home, please make sure the source router or ap features a Wps push Button.
NOTE:
the dap-1320 can also be configured using the web GuI. after you have plugged
the dap-1320 into a wall outlet and the power led is blinking amber, go to wireless
utility on your computer, select the dap-1320 network, and enter the password
(this is on your Wi-Fi configuration card). then open a web browser and type
http://dlinkap.local. By default, the username is Admin, and the password field
should be left blank. please refer to the product manual for further information on
configuring the dap-1320 using the web GuI.
DAP-1320
plug the dap-1320 into a wall outlet and wait until the
power led is blinking amber. push the Wps button
on the source wireless router or ap, and then push the
Wps button on the dap-1320. the led will start to
flash green.
please allow up to two minutes for the process to finish.
the led will turn solid green when the dap-1320 has
connected successfully to the source wireless router or
ap.
the dap-1320 is now ready to share the extended
Wi-Fi network with your pcs and mobile devices.
connect to the dap-1320 using the network
name (ssId) and password printed on your Wi-Fi
configuration card.
5