Lanaform Baby Camera Manual De Instrucciones página 5

3. INSTALLATION
3-1. Installation of the camera
1. Installation of the base of the camera
1. Never put the camera unit inside the bed or the baby's playpen
2. Put the camera at least 1 metre away from your baby.
3. The unit can be fixed to the wall or placed on a stable and flat surface, like a sideboard or a tabletop. For wall
mounting, please refer to our following schemes
4. Connect the camera to the adaptor, and then put the power button in position ON.
5. Make the round head of the camera swivel in an angle that allows practising surveillance.
Remark:
a. This camera can also use batteries as a source of supply. Please put 4 AA batteries (not supplied) in the compartment
located at the back of the camera and see to it that you respect their polarity.
b. Average data of constant functioning while using batteries :
5 hours (infrared OFF)
3 hours (infrared ON).
2. Configuration of the acquisition of data on the camera
In order to avoid the possible interferences intervening at the time you are using the camera,
Push the acquisition button « Learning ». Move the acquisition button at the back of the camera from OFF to ON, then Push the acquisition button « Learning ». Move the acquisition button at the back of the camera from OFF to ON, then
hold the stop button (for the alarm) «
screen.
There is not need to change the channel to avoid the interferences.
The range of the apparatus (without obstacles) is about 100 metres.
However, this range may be reduced to +/- 30 metres depending on the environment of the place of application
(the walls, ceilings,).
3. Configuration of the alarm of the camera
The camera has a function to detect sound.
The volume of the sound alarm is adjustable.
» of the receiver pushed in for 3 seconds. A clear image will appear on the
Baby Camera
EN
5