Lanaform Baby Camera Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
Configuration of the alarm for the detection of sound:
EN
In order to configure the sound alarm, put the alarm button on « VOX ». The system then goes into sound alarm mode,
which will allow it to detect sounds from 65 dB and to set off the alarm.
In case of the detection of a sound the alarm rings out during 2 minutes until the stop button for the alarm «
activated. You will then have to wait 35 seconds before the system goes into the sound alarm mode again.
If the stop button for the alarm is not pushed within 2 minutes, the sound alarm will stop automatically after this period
of time and the system will once again put itself into the sound alarm mode.
Configuration of the alarm OFF:
The alarm is not activated when the alarm button is in position OFF.
3-2. Installation of the receiver
1. Connect the receiver to the adaptor, and then put the power button in position ON.
2. Adjust the volume control to the desired level.
3. Configure the receiver on the same channel as the camera by pushing the channel button «
on the screen.
a. The original channel for the receiver is defined to correspond with the one of the camera.
b. A single camera is offered with this set. Nevertheless the receiver takes on up to 4 cameras working
b. A single camera is offered with this set. Nevertheless the receiver takes on up to 4 cameras working
simultaneously. If 2, 3 or 4 cameras are functioning, keep the channel button «
3 seconds to enter the automatic navigation mode and the system will alternate between the actual channels in
reason of 6 seconds each.
If you wish to have an extra camera at your disposal, please contact your retailer.
c. The monitoring screen turns black in the absence of a signal or interference.
Remark:
c. This camera can also use batteries as a source of supply. Please put 4 AA batteries (not supplied) in the compartment
located at the back of the camera and see to it that you respect their polarity.
d. Average data of constant functioning while using batteries :
5 hours (infrared OFF)
3 hours (infrared ON).
6
» is
»; the images appear
» pressed in for about

Publicidad

Tabla de contenido
loading

Tabla de contenido