System Connection - Party Light & Sound PARTY-200UHF-MKII Manual De Instrucciones

EN
5 & 6."RF" signal Indicator: It glows when the Receiver receives an RF signal from mic 1 & mic2.
7 & 8."AF"Audio Level Indicator: Indicate the wireless system audio signal level of channel 1 & 2.
9 & 10. Antenna channel 1 & 2
Rear panel
13
11. 5Vdc Power Jack: Connect the AC/DC adapter to receiver
12. Audio Output Jack 6.35mm: Connect the audio cable from this jack to the input port of amplifier, mixer.
13. XLR Balanced Output Jack: Connect the audio cable from this jack to the input port of amplifier, mixer.
MICROPHONE TRANSMITTER FEATURES
1. Grille: Protects the cartridge and
helps reducing the breath sounds and
wind noise.
2. Power & low battery indicator:
Steady on when the mic is switched
on and the batteries are full. Flashes
when the batteries run low and need replacement.
3. ON/MUTE/OFF switch: Switches the mic on or off.
TRANSMITTER BATTERY INSTALLATION
Push the battery cover open. Insert 2x AA batteries into the battery compartment
with the correct polarity. Close the battery cover.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household
waste but deposed correctly in accordance with your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed.Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns.Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.

SYSTEM CONNECTION

1. Receiver power connection: Connect the DC connector of the supplied AC/DC adaptor to the DC input
socket on the receiver. Plug the AC connector into an appropriate mains outlet.
2. Antennae: Keep the position of the antennae at an angle of 90°.
3. Audio connection: Connect the corresponding output of the receiver via a 6.35mm Jack lead to the input of
a power amplifier, mixer, etc.
TIPS TO ACHIEVE MAXIMUM PERFORMANCE
⠗
Make sure you can always see the receiver antenna from the transmit-
ter position.
⠗ Keep the distance from transmitter to receiver antenna as short as
possible.
⠗ Avoid placing the receiver antenna near metal surfaces and obstruction.
⠗ Monitor battery power and replace the battery as soon as the red light
goes on.
⠗ If stacking or rack mounting receivers in a multiple system, do not allow
antennae to touch or cross.
⠗ Perform a walk-through before performance or presentation. If dead spots are found, adjust location of the
receiver. If dead spots remain, mark them and avoid them during performance.
12 11
2
3
2 1
3