Introduction; How To Use; Safety - Vortice VortClean Mist Jet Manual De Instrucciones

ENGLISH

Introduction

Create safe spaces by preventing the spread of viruses and bacteria with contactless disinfection
of commercial and residential areas.
Designed for use with chemicals and disinfectants, VortClean Mist Jet uses an electric turbine
nebulizer technology that provides effective, long-range cleaning, offering a quick and convenient
option for both closed and open spaces.
Its ergonomic design and handle with integrated controls ensure a comfortable and user-friendly
operation, giving your spaces the safety you need.

How to Use

1. Fill the tank with your disinfectant or chemical of choice. Plug in the unit into the mains.
2. Adjust the straps to ensure a comfortable fit.
3. Turn on the unit with the ON/OFF switch on the handle and regulate the flow of liquid via the valve,
also located on the handle. Please note the pipe and handle could get hot during operation. This
is normal and is due to the high power of the jet.
4. Before turning off we recommend running VortClean Mist Jet for 5 to 10 seconds with the liquid
valve shut off, to avoid any spills of remaining liquid in the tubing.
5. After using the machine with chemicals use water to clean the tank and nebulize some water for
1 minute, raise the spray nozzle higher than the tank to let any leftover liquid reflow into the tank.
Afterwards empty the tank completely and run it without any liquid for 1 minute with the valve
open to dry out the tubing.

Safety

• Only operate VortClean Mist Jet after thoroughly reading this manual.
• Always use the product for the purpose it was intended, as specified in this booklet.
• After removing the product from its packaging, ensure that it is not damaged. If in doubt please
contact a VORTICE authorised T echnical Assistance Centre immediately. Never leave packaging
parts within reach of children or disabled persons.
• Cleaning and user maintenance shall not be made by children without supervision.
• Do not make changes of any kind to the unit.
• Periodically check device conditions. If imperfections are noted, do not use the unit and immediately
contact a VORTICE authorised T echnical Assistance Centre.
• Promptly contact a VORTICE authorised Assistance Centre in the event of unit malfunction and/or
failure.
• Do not spray any chemicals that do not comply with the safety regulations of your place of work.
• Do not put any highly flammable/volatile or corrosive liquids in the tank.
• Depending on the solution used, wear the appropriate protective gear.
• Do not let children operate the unit.
• Use supply voltage that matches the machine's specifications
• Avoid sharp objects scratching the power chord to prevent damage and short circuits.
• When storing the unit for a long time (more than 30 days) turn it on for 5 minutes every month with
the valve open to remove any humidity that might get trapped inside the tubing.
• Do not operate with wet hands.
• After using the machine with chemicals use water to clean the tank and nebulize some water for 1
minute. Then run it without any liquid for 1 minute with the valve open to dry out the tubing.
10