Fastening The Inverter To A Flat Surface; Connecting Inverter Cables - DieHard 71496 Manual Del Usuario

4.

fASTEnIng THE InVErTEr To A fLAT SUrfACE

For convenience your inverter can be fastened to a flat surface, horizontally or vertically. The area
where the inverter is to be fastened must be dry, well ventilated and away from any combustible
material or fumes.
1. Turn off and disconnect the inverter.
2. Place the back of the inverter with the mounting bracket against a secure and flat surface.
3.
Attach the inverter to the flat surface using corrosion resistant screws.
5.

ConnECTIng InVErTEr CABLES

The inverter and power source must be in the OFF mode.
Make sure you connect your inverter to a 12-volt power supply only.
InVErTEr ConnECTIon:
noTE: Determine whether you will be using the battery clips (425 watt output maximum) or the
12V accessory plug (100 watts maximum).
1. Locate the positive and negative plastic terminals located on the right side of the inverter
and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) terminal screw. Install the
negative (black) cable ring lug onto the negative (black) terminal screw. Tighten each
terminal so that the cable cannot come loose.
ConnECTIng InVErTEr CABLE To A VEHICLE (100 watts maximum):
1. Remove the cigarette lighter from its outlet.
2. Push the 12-volt power plug firmly into the outlet.
ConnECTIng InVErTEr CABLES To 12V BATTErY or 12V PoWEr SoUrCE (maximum
inverter output):
A SPArk nEAr THE BATTErY MAY CAUSE A BATTErY EXPLoSIon. To
rEdUCE THE rISk of A SPArk nEAr THE BATTErY:
DC Outlet
rISk of ConTACT WITH BATTErY ACId. BATTErY ACId IS A
HIgHLY CorroSIVE SULfUrIC ACId.
• 4 •
DC Plug