And Care Of Filters - Kenmore 758.15420011 Manual De Uso Y Cuidado

Replacement and Care of Filters
WARNING: To reduce the risk of
shock or iniury from moving parts,
always unplug humidifier before
removing or replacing any parts.
Lid
Fan Assembly
/
/
Humidifier
CAUTION: To help retard bacteria
growth and keep maximum
efficiency, the filter should be
replaced at least once per season,
or more often under hard water
conditions. Use Kenmore 32-14911
recommended replacement filter.
The filters may be rinsed periodically in
clear water only. Take care not to
damage paper. To replace evaporative
wicking filters in your humidifier, follow
these instructions.
1. Unplug humidifier before removing
the filters. We recommend moving the
humidifier to an area where floor
coverings are not susceptible to water
damage, i.e. kitchen or bath areas.
2. Open the pivoting lid and remove
water bottles and set aside. Grasp
the fan assembly front center and
rear center. Lift off and set aside on a
clean flat surface. The filter housings
are now accessible.
3. Lift filter housing out of cabinet and
place where you may work on them
comfortably. With a soft, absorbent
cloth remove any remaining water or
loose mineral deposits not trapped in
the filter from the humidifier cabinet.
4. To open filter housing for easy access
to filters:
a. Deflect the two spring tabs on top of
filter housing. Lift top cover off of the
filter housing and set aside.
b. Remove the two filters and dispose of
properly. Clean internal parts of
humidifier per the "Cleaning and
Maintenance" section (page 12) of
your operator's manual.
Spring
_ ilter
Housing
J
Spring
Tabs
Fixed Tabs
Front of
Humidifier
c. Install new filters in the filter housing
track with the glue beads of the
wicking pad to the inside of the filter
housing.
d. Return the top cover of the filter
housing by installing cover over the
fixed tabs on the rear of the lower
filter housing and pivoting the cover
down over the top of the filters. Snap
the cover over the two spring tabs.
11