Circuit Diagram; Care And Cleaning - Home Decorators Collection 27-900-002 Guía De Uso Y Cuidado

Maintenance (continued)
Disconnect power before servicing.
Any electrical re-wiring of this appliance must be done by a qualified electrician. This wiring must be done in
accordance with local codes and/or in Canada with the current CSA C22.1 Canadian Electrical Code, and for US
installations, the National Electrical Code ANSI/NFPA NO 70.
If repairing or replacing any electrical component or wiring, the original wire routing, color coding and securing
locations must be followed.

CIRCUIT DIAGRAM

L
N
GND
AC120V/60Hz
WARNING: Disconnect power before servicing.
Care & Cleaning
L
□ Always turn the heater OFF and unplug the power cord from the outlet before cleaning.
□ Cleaning of the control panel, located in the upp right-hand corner of the fireplace behind the sliding control panel cover, is to be done
N
GND
only using a soft cloth, slightly dampened in water (if needed, a small amount of dish soap can be added to the water) and dried using
AC120V/60Hz
a clean, dry soft cloth. Cleaning of the screen diffuser is to be done using only water and lint free cloth. DO NOT use any abrasive
controls and the diffusing screen.
AVERTISSEMENT: COUPLEZ L'ALIMENTATION AVANT D'EFFECTUER L'ENTRETIEN.
L
RLY3
RLY4
RLY1
RLY2
N
CIRCUIT
BOARD
WARNING: DISCONNECT POWER BEFORE SERVICING.
L
RLY3
RLY4
RLY1
RLY2
N
CARTE DE
CIRCUIT
IMPRIMÉ
DANGER
THERMAL
CUTOFF
FLAME LED
POWER I/O
FLAME I/O
HEATER I/O
TIMER I/O
THERMAL
CUTOFF
DEL DE FLAMME
E/S DE PUISSANCE
E/S FLAMME
E/S RÉCHAUFFEUR
E/S TEMPS
12
THERMAL
FUSE
FAN
HEATER
FLAME EFFECT
MOTOR
EMBER
BED LED
FUSIBLE
THERMIQUE
RADIATEUR DU
VENTILATEUR
MOTEUR D'EFFET
DE FLAMME
DEL DU LIT
DE BRAISE
HEATER
ELEMENT
ÉLÉMENT
CHAUFFANT