Craftsman 917.28921 Manual Del Operador página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Keys
(1) Oil Drain Tube
For Future Use
Slope Sheet
(2) Keys
Your new tractor has been assembled
at the factory with the exception of those parts left
unassembled
for shipping purposes.
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating posi-
tion (seated behind the steering wheel).
TO REMOVE TRACTOR
FROM
CARTON
UNPACK CARTON
1. Cut along dashed lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
2. Remove protective
materials from trac-
tor hood and grille.
IMPORTANT:
Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
TO CHECK
BATTERY
1. Lift seat to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals)
charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY"
in Maintenance
section of this
manual for charging instructions).
For batteryand
battery cable installation
see "REPLACING
BATTERY"
in the
"Service
and Adjustments"
section
in
this manual.
Label
ADJUST
SEAT
1.
Sit in seat.
2.
Lift up adjustment
lever
(A) and slide
seat until a comfortable
position
is
reached
which
allows
you to press
clutch/brake
pedal
all the way down.
3.
Release
lever to lock seat in position.
NOTE: You may now roll your tractor off
the skid. Follow the appropriate
instruction
below to remove the tractor from the skid.
WARNING:
Before starting, read, un-
derstand and follow all instructions
in the
Operation section of this manual. Be sure
tractor is in a well-ventilated
area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL
TRACTOR
OFF SKiD
(See Operation
section
for location
and function
of controls)
1. Raise attachment
lift lever to its high-
est position.
2. Release parking brake by depressing
clutch/brake
pedal.
3. Place gearshift lever in neutral posi-
tion.
4. Roll tractor forward off skid.
5. Remove banding holding the deflector
shield up against tractor.
Continue with the instructions that follow.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido